Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tool Description Variable

Status
Not open for further replies.

MtnJunkie360

Aerospace
Jul 30, 2013
15
In NX 8.5, when using a tool from the library, there is the catalog name...
But if you click in to edit the tool, there is also a tool description ie... tool UGTI0201_012 has a description of " End Mill 1/2" "
is there a mom variable to pull this description into post builder?
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor