EEnd
Mechanical
- Feb 6, 2004
- 636
I just upgraded from 2009 SP5.1 to 2010 SP5.0 and then from 2010 SP5.0 to 2011 SP5.0. Everything looked OK in 2010. The conversion to 2011 did not go as well.
We use the "Create Parts" option for the toolbox where a part is created for each fastener, as opposed to using a configuration in the master file.
In 2011 converted assemblies, some but not all of our fasteners are being replaced by new ones that are being generated from the toolbox.
This seems similar to thread559-292953. Has anyone else suffered similar experiences?
Eric
We use the "Create Parts" option for the toolbox where a part is created for each fastener, as opposed to using a configuration in the master file.
In 2011 converted assemblies, some but not all of our fasteners are being replaced by new ones that are being generated from the toolbox.
This seems similar to thread559-292953. Has anyone else suffered similar experiences?
Eric