Toolbox Description not showing in BOM

[captaincaveman747]

We use a specific BOM that uses Item,Quantity,partnum(custom property),and partdescription(custom property).
In SW 2007 the toolbox parts used to come into the BOM just fine but now all I get from 2008 is blank entries in my BOM. Anyone else have this problem?

Captain Caveman
Almex Industries,Parry Sound ON.Canada\
SW2008,SP 0.0
Intel P4 3.0 Ghz,Quadro FX500,1 Gig Ram

 

[CorBlimeyLimey]

Is your 2008 install looking at the 2007 Toolbox location? Or is it looking at a newly installed 2008 version.

 

[captaincaveman747]

Yes the common toolbox location on the network drive was repointed. Did a little reading on the SW site and it seems there are a few SPR that bear resemblance to this issue still unresolved.


Captain Caveman
Almex Industries,Parry Sound ON.Canada\
SW2008,SP 0.0
Intel P4 3.0 Ghz,Quadro FX500,1 Gig Ram