Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TRACE 700 thermal modelling -wall numbering

Thread starter newmind
Start date Jan 15, 2009

Status: Not open for further replies.

Jan 15, 2009

newmind

Mechanical

I created the space & zone by using Autocad MEP 2009 then exported it to TRACE using GBXML, is there any easy way to verifying the wall numbering? It seems the TRACE numbered it in sequence. I am verifying it against the CAD drawing so I can change the wall into partition.