Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trying to get info for a datum plane crashes Creo

Status
Not open for further replies.

treddie

Computer
Dec 17, 2005
417
US
Hello.

I have had this problem for some years and usually just brushed it off. Now, I need to do this and it appears to be a bug in Creo2.0. If I create a datum plane, and then try to do right-click > Info > Feature, Creo crashes. Has anyone else seen this problem? I thought it might be my personal config.pro file with old remnants from Wildfire, but even if I use Creo's default config.pro file, the same thing happens.

Any guidance on this would be super!

 
Replies continue below

Recommended for you

What build of Creo 2.0 are you using?

when Wildfire 1 was released as pre-release version C000, I could build a cube and the software would crash when I went to complete the steps.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Thanks for replying, looslib.

Creo 2.0 M100
 
Info-Feature on a select plane created in Creo2 m250 works fine.

Can you upgrade to a newer release?

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
If you have support from PTC just submit a case to them. I think Creo 2 is still supported.

----------------------------------------

The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
 
Great tips, guys. I guess it's time to upgrade!

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top