tubing design

[sudhakarn]

Hi,
I am unable to define a run for a product opened from the enovia.This is actually a vehicle.the run toolbar is highlighted only when i activate the insatance of the product and even then i am getting the error as "unable to create run for the CAT Part.Activate the CAT Product ". Any body has any idea?

When i am working in a local product file it is fine there is no issue.

 

[itsmyjob]

my guess is that tubing only works in CATProduct file, not enovia structure, at least with Enovia VPM V4.
V6 is something else.

Eric N.
indocti discant et ament meminisse periti ​

 

[sudhakarn]

thank you sir.I am also of the same opinion.

 

[KevinDeSmet]

Make sure you are using a "Publications Exposed" product in ENOVIA. This will mean your product will show in the ENOVIA tree as a single "blackbox" node. When you open this in CATIA you will see the entire structure show up. I am not totally familiar with Tubing and it'll depend on which version of VPM you got. But I am coming at this suggestion from an Electrical Harnessing and VPM 1.6/3dcom background.

 

[sudhakarn]

hi,

Thank you so much kevin.Will check it and get back to you.