Piper_at_work
Mechanical
- Aug 23, 2019
- 3
Hello!
I have been reviewing some nozzle orientations for agitated vessels, and it has come to my notice that the nozzle for the level switch (tuning Fork type) is oriented adjacent to the pump recirculation inlet nozzle. Level switch installation guide recommends the switch should not be near any inlet nozzle.
How bad could be the implications of such an orientation? Is there anything that can be done to nullify them since the orientation has already been sent for fabrication?
Regards,
Piper
I have been reviewing some nozzle orientations for agitated vessels, and it has come to my notice that the nozzle for the level switch (tuning Fork type) is oriented adjacent to the pump recirculation inlet nozzle. Level switch installation guide recommends the switch should not be near any inlet nozzle.
How bad could be the implications of such an orientation? Is there anything that can be done to nullify them since the orientation has already been sent for fabrication?
Regards,
Piper