pdelnet
Mechanical
- May 13, 2005
- 115
when viewing a part using the two view horizontal active-
(The flat pattern is not a derived configuration if that matters, it is created with shared profile geometry)
Anyone know if this is possible - I have run out of ideas to try...
SW 2014 SP 5.0 x64
-
The model has 2 configurations, 1 as formed (rolled), 1 as a flat pattern
I would like to see the model in the top view in the rolled configuration
and the model in the bottom view as a flat pattern,(The flat pattern is not a derived configuration if that matters, it is created with shared profile geometry)
Anyone know if this is possible - I have run out of ideas to try...
SW 2014 SP 5.0 x64