UDO icons in part navigator

[RX8UK]

Is it possible to define the icons shown in the part navigator that represent UDO features?

Many thanks in advance if you can show me how.

Regards,

Paul

 

[NutAce]

Only solution would be (I guess) is to find the bmp/png that is used (NX installation location) and replace it with the one you would like.
Make sure it uses the correct name and format.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11

 

[RX8UK]

Thanks NutAce but that would change it for all udo features regardless of type. Modifying defaults is never a good idea.

 

[NutAce]

Thanks NutAce but that would change it for all udo features regardless of type. Modifying defaults is never a good idea.

You are absolutely correct. But the question didn't state you needed a different Icon for each type of UDF.

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11

 

[RX8UK]

NutAce, I'm not trying to alienate but I did state "icons".

Thanks again for your input.