ug nx 6.0.5.3 mp1 64 bit freezes when I move toolbars

[pcommins]

I have recently switched to 64 bit work stations running windows 7. My ug nx 6.0.5.3 mp1 install freezes up if I try to move tool bars. I have to use task manager to close it out when that happens. Any Ideas as to what is causing this? or What I can do to fix it. Thanks in advance for the help

Phil

 

[JohnRBaker]

I would contact GTAC and have them look at your configuration including your graphics card and the driver that you have installed. If you haven't done so yet, I would verify that the display driver was up-to-date and one which we have certified.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

It's a known problem when you use Nx and MS Internet Explorer 9.0

 

[JohnRBaker]

Yes, I'm still running EI 8.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[pcommins]

Thanks, I went back to Ie8 and it fixed the problem. Thanks again.