UGNX-5 - How to Create Animation 1

[bmaverick]

Per the question in thread561-271903

My problem is the same issue trying to make a virutal walk-through of a manufacturing plant rather than an airport.

No, I do not want to move components nor have the assembly lines running. Just a virtual tour by walking through the plant via the UGNX Create Animation. Veiw > Visualization > Create Animation

The GTAC Q1, Q2 and Q3 of 2002 were useless in helping as someone tried to offer the advise. That talks about moving components via animation.

Help.

 

[JohnRBaker]

This is something that can't really be explained using a message board. You will need to find someone who knows how to do it and have them teach you or else you will need to try and learn it by reviewing the user documentation, which you can find at...

Gateway to NX -> Viewing Files -> Animating Models -> Animation as well as -> Trajectories for Navigation and Animation

Note that the 'Trajectories for Navigation and Animation' are probably going to be of more value for what you're describing than would be simple 'animation' but they are part and parcel to each other.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[FelixMuehlhoff]

I wrote a small docu for this months ago. Perhaps it helps.

Regards

Felix

 

[bmaverick]

+star for Felix !

I'm now getting the understanding on how this animation works in NX.