Sep 25, 2009 #1 wayneski69 Structural Aug 14, 2009 2 Is it possible to ultrasonic test 3" sch 80 pipe of material 316 L -S .
Sep 25, 2009 #2 rustbuster Petroleum Jul 7, 1999 289 Yes it is, your calibration block should be of the same material. Upvote 0 Downvote
Sep 26, 2009 #3 HouseHark Industrial Sep 2, 2006 17 3" is quite small for normal UT. Haven't a schedule list but I know its low wall thickness also. Spec we use wont allow UT on anything less than 5" OD or 10mm WT. Upvote 0 Downvote
3" is quite small for normal UT. Haven't a schedule list but I know its low wall thickness also. Spec we use wont allow UT on anything less than 5" OD or 10mm WT.
