undo erasing

[rgajewski]

This I hope is just a setting issue, but when I erase features I can not "undo" and get them back. Though the software goes through the appropriate "undo" steps. It's just that the lines/parts that were erased do not show up again.
Thanks for the help.

Every once in a while the voices in my head have a good idea.

 

[borgunit]

Do you have any of the UNDO "switches" (options) on?

"Everybody is ignorant, only on different subjects." — Will Rogers

 

[JStephen]

Did you perhaps do a save after erasing? (Can't undo after a save).

Could the items perhaps be hidden due to display order? Seems like I have hit this problem before.

Just a couple of ideas...

 

[TCARPENTER1]

Hi rgajewski,

Hmmm... I wonder if this is just a refresh issue. After you issue your undo command you may try a regen or regenall (or even a redraw) and see if your geometry reappears. Also, don't forget when you undo, AutoCAD undoes any zooms, dynamic or otherwise, maybe you didn't undo far enough back? You may also try the "oops" command - this one just undoes erases.

HTH
Todd

 

[rgajewski]

UNDO is set to ALL. Thanks.

Every once in a while the voices in my head have a good idea.

 

[IFRs]

oops un-erases the most recent erase