unigraphics 13 printer/plotter setup 1

[caddman45]

We have had to revive our Unigraphics DEC ALPHA Workstaions.
Does any one have the knowledge available to set up printers/plotters?
Thanks!

 

[looslib]

Why?????

Can't you transfer the files to a newer version.
Ug is upward compatable. I have V10 files that I have opened in NX1.


"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[caddman45]

Well, it goes like this. We had UG and now we are stuch with Autodesk Inventor! They stopped UG @ version 14.
So that is why I ask..................

 

[looslib]

Plotter setup in V13 was done with a dedicated IP address of the plotter and then the UGII PlotQueMgr was run with the output being set to the potter IP, I think.

I think we cleaned out all of our pre-v16 manuals a while ago.


"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand

 

[cobom]

If it was like V15 you load printer drivers, share out the printer, and run pqmgr. There are preloaded examples that you can modify.

This was for Windows though.

 

[caddman45]

Than you all for the info!