Nov 17, 2011 #1 tmmoreno Mechanical Sep 15, 2008 4 0 0 US I am looking for the toggle for the pre-selection hi-lite in NX, If I am not mistaken, when you put your curser over a component in an assembly it will hi-lite for selection. Where is the toggle? tmmoreno
I am looking for the toggle for the pre-selection hi-lite in NX, If I am not mistaken, when you put your curser over a component in an assembly it will hi-lite for selection. Where is the toggle? tmmoreno
Nov 17, 2011 #2 JohnRBaker Mechanical Jun 1, 2006 35,346 2 38 US Go to... Preferences -> Selection... ...and make sure that the first option, 'Highlight Selection on Rollover' is toggled ON in the 'Highlight' section of the dialog. John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA http://www.siemens.com/plmUG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209 To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
Go to... Preferences -> Selection... ...and make sure that the first option, 'Highlight Selection on Rollover' is toggled ON in the 'Highlight' section of the dialog. John R. Baker, P.E. Product 'Evangelist' Product Engineering Software Siemens PLM Software Inc. Industry Sector Cypress, CA http://www.siemens.com/plmUG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209 To an Engineer, the glass is twice as big as it needs to be.