Uniting Two Bodies

[ViniciusV]

Hi all,

I just modeled two different bodies and in assembly I saw that it will be easier if these bodies were only one. How can I unite two bodies? Can't find that option.

Thanks

 

[MickyV007]

Insert - Combine - Unite. if searching for a specific command you can always use the Command Finder function, very helpful.


Best regards,

Michaël.

NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit (Intel(R) Xeon(R) CPU X5650 @2.67GHz)
24.0 GB
NVIDIA Quadro 4000 + NVIDIA Tesla C2050

 

[jerry1423]

So you have two seperate bodies in an Assembly, correct?

 

[ViniciusV]

Yes jerry, the combine command doesnt seem to work.

I forgot to inform, I'm using NX 8.

Thanks

 

[ViniciusV]

Nevermind, I figured out how to do it.

Thanks to all of you.

 

[jerry1423]

How did you do it?

 

[ViniciusV]

In Assembly I set the part I wanted to unite to work part. Created a dumb body and used the interference command. After the interference body was created I selected both and asked NX to leave only the interference body between them both, leaving the body shape I wanted, then I united this new body to the one I wanted.