Spaceballster
Mechanical
- Jun 18, 2009
- 49
Hi,
When modelling in 3D I always turn off units in value fields because it's just so much quicker that way. However, when I make my drafts I have to remember to turn the units back on or else the weights will not show their units in my BOM.
Besides remembering, is there a trick or a macro that will enable untis in value fields in draft environment and disable them in modelling environments?
Thanks,
Griffin
When modelling in 3D I always turn off units in value fields because it's just so much quicker that way. However, when I make my drafts I have to remember to turn the units back on or else the weights will not show their units in my BOM.
Besides remembering, is there a trick or a macro that will enable untis in value fields in draft environment and disable them in modelling environments?
Thanks,
Griffin