Use existing sketch for Hole Wizard?

[brrian]

I think I know the answer to this (no), but can you preselect an existing sketch to use with the Hole Wizard--a sketch that includes points? If no, I may submit an enhancement request.

From my limited experience with Inventor, I know that you can do it in there, and you can even select line/arc endpoints as hole locations--they don't have to be sketched points (that's about all I liked in Inventor).

Thanks,

Brian

 

[CorBlimeyLimey]

You are correct ... the answer is no, but you can use the geometry in an existing sketch to position the new points for the HW.

& all the best.

 

[brrian]

I did know that you can do that... I'm not sure that I'd use it much. It creates another parent-child relationship. I'd sooner just put the extra geometry in the hole sketch.

Thanks for the quick response!

Brian