Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using a datum Csys in NX11 PTS

Status
Not open for further replies.
Andythebod

Andythebod

Automotive
Nov 21, 2019
2
thread561-419439

its been awhile since I have done it but I seem to remember having the ability to used wave linked datum csys in the PTS author.

it used to be done in UDF's wondering if there is a switch I need to set to enable this.
 
Status
Not open for further replies.

Similar threads

Werner K
  • Locked
  • Question
Clone PTS part to subassembly
Replies
0
Views
98
Werner K
Werner K
3dr
  • Question
Drafting Files with mixed units failure, NX11
Replies
3
Views
829
Toost
Toost
mugler02
  • Locked
  • Question
Specialist Durability analysis using a nonlinear solver in Siemens NX
Replies
0
Views
110
mugler02
mugler02
grizzlyadam
  • Locked
  • Question
PTS Visual Rules Help: Replace Component
Replies
1
Views
133
Toost
Toost
R
  • Question
I am having issues using the split body command in NX FEM software
Replies
1
Views
1K
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top Bottom