Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using only substructures

Status
Not open for further replies.

StefCon

Mechanical
Joined
Mar 6, 2013
Messages
155
Location
SE
Hello,
Is it possible to create a model only using one or more substructures (no other mesh elements)?

Example: Create a substructure of a beam and retain 6 DOF for each end. Create a cantilever setup with the substructure in an implicit static step. One substrucure, one boundary condition (encastre) and one load.


Thanks.
 
Sure, you can do it this way. Give it a try. Just keep in mind that you have to request field output for a substructure and use the abaqus substructurecombine command after the analysis is completed (the same workflow as for analyses involving both substructures and regular elements).
 
Thank you for the quick response!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top