Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UT Lamination of Plates Requirements

Status
Not open for further replies.
napster385

napster385

Petroleum
Apr 4, 2013
34
Is it required in ASME VIII to conduct UT lamination check of steel plates? If not, when is it required? Is it also respective to thickness of plates?

Appreciate your comments.

 
Status
Not open for further replies.

Similar threads

mariolucas75
  • Locked
  • Question
Nominals for steel plates 2
Replies
4
Views
404
racookpe1978
racookpe1978
H
  • Question
NACE Requirements for completely Cladded pressure vessel in severe sour stream
Replies
5
Views
2K
SJones
SJones
AlbeBersani
  • Locked
  • Question
PWHT requirements for 304H prefabrication 1
Replies
6
Views
426
GD2
GD2
pperlich
  • Locked
  • Question
SA-20 and SA-414 Marking Requirements for Plates Produced from Coil
Replies
0
Views
169
pperlich
pperlich
Andrew63411
  • Locked
  • Question
Code requirements around using 309L weld overlay as part of pressure boundary thickness
Replies
12
Views
686
jt1234
jt1234

Part and Inventory Search

Sponsor

Back
Top Bottom