Hi all,
We have just upgraded our machines from NX4 to NX5. We are due to go live in the New Year and so we are carrying out some initial testing to ensure all is well.
We have one machine that has a little problem in calling a UTD dialog box in NX5. The UTD box flashes for a split second (if you blink you'd miss it) and then dissappears. The utd works fine on the same PC in NX4. The other machines I've looked at so far are working as expected in both NX4 & NX5.
Any ideas?
Could there be a setting that has been ticked on this machine?
Could it be an IT issue?
We are stumped at the moment, so any advice would be very much appreciated.
Many thanks,
Andy.
---------------------
(Using: UG NX4)
Design Engineer
We have just upgraded our machines from NX4 to NX5. We are due to go live in the New Year and so we are carrying out some initial testing to ensure all is well.
We have one machine that has a little problem in calling a UTD dialog box in NX5. The UTD box flashes for a split second (if you blink you'd miss it) and then dissappears. The utd works fine on the same PC in NX4. The other machines I've looked at so far are working as expected in both NX4 & NX5.
Any ideas?
Could there be a setting that has been ticked on this machine?
Could it be an IT issue?
We are stumped at the moment, so any advice would be very much appreciated.
Many thanks,
Andy.
---------------------
(Using: UG NX4)
Design Engineer