Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Utilization Ratio / Safety Factor / Postprocessing

Thread starter TomekZeWschodu
Start date May 18, 2015

Status: Not open for further replies.

May 18, 2015

TomekZeWschodu

Marine/Ocean

Hi All,

I have done an Advanced Simulation (SOL101) in NX9 and would like to display (do the result postprocessing) a utilization factor for each element with respect to it's own Yield Strength.
I have more than one material used in the analysis so simple reduction of the Stress is not a solution.

Any ideas ?

Naval Architect/ Structural Engineer