Sep 23, 2003 #1 hutch56 Automotive Sep 23, 2003 12 0 0 US I am trying to cut and paste a feature created in Generative shape (loft) but when I paste into a new part I get the following: Update Diagnostics - Invalid token input? seems to be looking for ref. geometry?? Thanks in advance!
I am trying to cut and paste a feature created in Generative shape (loft) but when I paste into a new part I get the following: Update Diagnostics - Invalid token input? seems to be looking for ref. geometry?? Thanks in advance!
Sep 23, 2003 #2 itsmyjob Mechanical Apr 11, 2002 2,375 0 0 CA hi, do you have any axis in your part ? did you use that axis to create any link (for a sketch plane? for a sketch ref ?) most of the time, using the axis is no good, use default ref plane or build some line if you need axis (line PT/dir) Hope that will help Eric N. catiav5@softhome.net Upvote 0 Downvote
hi, do you have any axis in your part ? did you use that axis to create any link (for a sketch plane? for a sketch ref ?) most of the time, using the axis is no good, use default ref plane or build some line if you need axis (line PT/dir) Hope that will help Eric N. catiav5@softhome.net
Sep 24, 2003 Thread starter #3 hutch56 Automotive Sep 23, 2003 12 0 0 US I haven't created an axis, part was imported from V4. I have used the extract command on the surface to break the link back to the supporting wirefreame and points. Thanks! Upvote 0 Downvote
I haven't created an axis, part was imported from V4. I have used the extract command on the surface to break the link back to the supporting wirefreame and points. Thanks!