Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

V5 drawing from CGR / large assy

Status
Not open for further replies.

Crazyfrog

Aerospace
Sep 21, 2005
10
GB
To make drawing (even section cuts) of largy assy or CGR files, you can use the approximate drawing option :

Option/mechanical design/drafting/view/view generation/approximate

It will avoid a lot of crash and "command interrupted" !
(V5 can not deal with more than 1G/1.5G of memory)
 
What are CGR Files?
 
^^ CATIA Graphical Representation.

It's what you see when you are in visualization mode, for example. It's just a graphical representation of the actual geometry.

 
Can you get a section view associative?

Because when I create a section view from cgr-files (approximate view) I get the message "Your profile will not be associative"

Is this a setting problem?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top