Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

V5 Tubing workbench R12 - Spec driven working?

Thread starter AXXX
Start date Oct 21, 2004

Status: Not open for further replies.

Oct 21, 2004

AXXX

New member

Hi,

Anyone using in production the Spec driven Part placement within the Tubing workbench?
We are still unsure if it is performing as it should, even though DS says "working as designed".

Any good, bad or impartial opinions about the Tubing Design workbench?

Regards
AXXX