Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

V5R21 Dynamic Sectioning - show/hide section cap

Thread starter rattler
Start date Nov 17, 2014

Status: Not open for further replies.

Nov 17, 2014

rattler

Mechanical

Hi,

I'm using dynamic sectioning in Part Design and have inadvertently changed a setting so that I now see the inside and outside surfaces but not a solid "cap" coloured green as it was previously set. This allows you to see right inside the part but is confusing. Can anyone tell me where the controls for this tool are please as I'd like to change it back? It must be part specific as I don't have the problem with other models.

Thanks