variational sweep, through curve, or something must be easier 1

[BOPdesigner]

NX 5.0.5. I needed to change a chamfer as shown in the attached part file to a variable chamfer that joins the top face to the through hole as shown in the screen capture. In the screen capture is the set of features boxed in red that we ended up with to complete this task. When somebody has a minute, can you show me the easier way using the part file provided?

 

[JohnRBaker]

OK, how about this...

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[BOPdesigner]

Yes that is beautiful. For some reason when I was trying the sweep earlier it was choking on the closed loop circle being the guide. Never used the patch feature before so I will have to learn that one. Thank you.