Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

volumetric lubrication pressure release problem ILC MPT 500 MODEL

Status
Not open for further replies.

Ahammed Islam

Mechanical
Aug 23, 2020
1
Dear mentors
IMG_20200819_130438_2_bxfycb.jpg


we are using several ILC lubrication MPT-500 model system.

during operation motor runs and raise pressure to 35 bar, during release from 35bar to zero motor turns back.we have total 5 system.

but one of our system pressure release taking too much time, motor do not rotate back during release, and system says lubrication line in pressure.pressure raise normally till 35 bar but release taking too much time

i couldn't figure out where is the release valve, or why its taking too much time to release pressure, and why motor don't turns back during release.


best regards
Ahammed Islam
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor