Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Waard Model for corrosion allowance

Status
Not open for further replies.

rachba

Materials
Oct 6, 2015
18
Hi!
Normaly,the waard model is for pipeline in wet conditions, but Is it possible to use it for the calculation of the corrosion allowance for a tank or a scrubber for exemple
Thank you
 
Replies continue below

Recommended for you

It would not normally be applied to an atmospheric tank. It is feasible to gain an insight into fluid corrosivity within pressure vessels with the model but this will require some interpretation as to the flow conditions within the vessel.

Steve Jones
Corrosion Management Consultant


All answers are personal opinions only and are in no way connected with any employer.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor