I want to nozzle a water flow and then diffuse it to slow the jet down. I.e. I need to maintain a pressure up to point and then diffuse it.
If my diffuser is below the 7 deg included angle. Can anybody point me to some design guidelines for the diffuser. I.e. presumably I get to a point where the water , upon opening out, and slowing down, gravity then takes over and it seperates from the diffuser walls.
(I.e. if you imagine this is a vertical arrangement the diffuser could be so large that the water velocity was very low and essentially hanging 'in mid air' in the diffuser, if it did not seperate.)
thanks
If my diffuser is below the 7 deg included angle. Can anybody point me to some design guidelines for the diffuser. I.e. presumably I get to a point where the water , upon opening out, and slowing down, gravity then takes over and it seperates from the diffuser walls.
(I.e. if you imagine this is a vertical arrangement the diffuser could be so large that the water velocity was very low and essentially hanging 'in mid air' in the diffuser, if it did not seperate.)
thanks