wave geometry linker in NX9

[battus]

Hi all,

can any one please provide the procedure for creating the wave geometry linker.

i have done assembly for some parts, i need to do some machining operations on that assembly. how can i do this??

i tried using wave geometry linker, seperate linked bodies are creating for each part. I need to do the machining on the assembly.

can you guys please give a suggestion on this.

Regards,
Battu

 

[SvenVoeten]

Hi,

You should have better succes with your question on the forums below...

http://www.eng-tips.com/threadminder.cfm?pid=561

https://community.plm.automation.siemens.com/t5/NX-Design-Forum/bd-p/NXDesignForum

If with machining you mean CAM then ask on the manufactering forum...

https://community.plm.automation.siemens.com/t5/Discussion-Forum-NX/bd-p/open_forum

 

[battus]

Thank you very much SvenVoeten