Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Wave runup analysis 1
- Thread starter KMsalem
- Start date
-
1
- #2
Marinelogistics
Marine/Ocean
We have received reply from Eric france for slipway pull.
We have used winch capacity of 20tons but it has fail to pull the vessel.
However we have used two single sheave pulley blocks and made the pulling ropes as three falls.This has helped to pull the vessel up.
Now we are having 250 mm wheel diameter and if we increase the diameter to 500 mm then the pulling capacity by the winch will be reduced.
By how much percent it will be reduced?
We have used winch capacity of 20tons but it has fail to pull the vessel.
However we have used two single sheave pulley blocks and made the pulling ropes as three falls.This has helped to pull the vessel up.
Now we are having 250 mm wheel diameter and if we increase the diameter to 500 mm then the pulling capacity by the winch will be reduced.
By how much percent it will be reduced?
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question