Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Way to turn off coordinates that follow around cursor in Sketcher 1

Status
Not open for further replies.

Purdue79

Mechanical
Sep 20, 2012
11
Is there a way to turn off that box that has XC and YC in it and follows around the cursor in Sketcher? I am using 7.5.5.4. Any help would be appreciated. Sorry if this has already been covered but I could not find anything.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor