Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Welder Performance Qualification

Status
Not open for further replies.

ISDQAQC

Specifier/Regulator
Joined
May 12, 2006
Messages
9
Location
JP
Conducting a review of Contractor's Welding Procedures, I find where welder qualifications are conducted by and outside testing lab. I note there is no reference to the actual PQR's used to qualify the original WPS listed on the test. Is this acceptable ? Can you direct me to any statements regarding this in Section lX. Thank you in advance for assistance.
 
For welder performance qualification, Section IX recommends only the WPS is identified for the welder performance and not the associated PQR on Form QW-484A. See suggested format of Forms in Section IX, Non mandatory Appendix B.
 
metengr,

Thank you very much for the prompt reply. wjs
 
See paragraph 301.2 of ASME Section IX which there is a statement as the following :
The welder or welding operator who prepares the WPS
qualification test coupons meeting the requirements of
QW-200 is also qualified within the limits of the performance
qualifications, listed in QW-304 for welders and in
QW-305 for welding operators. He is qualified only within
the limits for positions specified in QW-303.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top