Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
What is the partial pressure limit
- Thread starter ENGRANIA
- Start date
EdStainless
Materials
What does the spec that you are working with say?
Each of the specs lists alloys and the limits for H2S, temp, pH, and other criteria.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
Each of the specs lists alloys and the limits for H2S, temp, pH, and other criteria.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
- Thread starter
- #3
As much as you want if the carbon steel has the correct properties. This is from a cracking point of view. High H2S may cause other corrosion issues.
[URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1678352593/tips/Interpretation_c12rtq.docx[/url]
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
[URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1678352593/tips/Interpretation_c12rtq.docx[/url]
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
I don´t know your operation pressure, but i think for a partial pressure of 0.05 psia, you are well inside in materials required by NACE 0175
EdStainless
Materials
As Mr. Jones pointed out, the NACE spec just addresses cracking.
You need to also consider all other forms of corrosion that might impact service.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
You need to also consider all other forms of corrosion that might impact service.
= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed
- Thread starter
- #7
- Thread starter
- #9
@ENGRANIA
This is an equipment type, not an industry. Check ISO 17945, ISO 21457, ISO 15156, NACE 8X194, NACE MR0103, NACE RP0296 for applicability. Note that standard applicable is affected by CO2 content and similar factors. Also para. 8 API 581 and DNVGL's report #14671 "Neutral and High pH SCC" might be useful.
This is an equipment type, not an industry. Check ISO 17945, ISO 21457, ISO 15156, NACE 8X194, NACE MR0103, NACE RP0296 for applicability. Note that standard applicable is affected by CO2 content and similar factors. Also para. 8 API 581 and DNVGL's report #14671 "Neutral and High pH SCC" might be useful.
Nothing like a bit of carpet bombing
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
- Status
Similar threads
- Locked
- Question
- Locked
- Question