When zooming out in Drafting, lines disappear

[Munnichs]

I have a problem in Drafting with NX 6.0.5. When you for example zoom in to a view, add some balloons, and then zoom out, not all lines are visible (they disappear). After refresh/update, the lines will be visible again. See attached pictures.



It started happening when we installed MP1. Does anyone else has this problem?

Kind regards,
Roy Munnichs

 

[JohnRBaker]

This issue was already being beaten to death on the other thread to which you had just responded 12 minutes BEFORE you started this one.

There was no need to open a second thread since if we're not going to fix this in an NX 7.5 MP, we are certainly NOT going to go back and do so in an NX 6.0 MP and since the last NX 6.0 MR has been released, you will have to wait for NX 7.5.1.x for a resolution to this issue.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[Munnichs]

John,

The reason I started this thread in the first place is that, despite several phonecalls to the Dutch Siemens helpdesk, I didn't get a any information about this issue at all ! If they told me that it was a known issue then I didn't have to bother you with this.

Since in the other thread it concerned NX 7.5, I thought that there maybe was a solution for NX 6.0.5, but according to your comment that is very wishfull thinking. Luckily for me it wasn't the first time I receive such an answer for an NX issue.....

Kind regards,
Roy Munnichs.