Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Which is the result coordinate system in POST26?

Status
Not open for further replies.
Lirock

Lirock

Mechanical
Joined
May 27, 2006
Messages
75
Location
CN
Hi,everyone:
In POST1,we can use command 'RSYS' to modify the result coordinate system,but 'RSYS' is not a known command in POST26. Then which is the result coordinate system in POST26?

Rock Li
 
Sort by date Sort by votes
Hello,

You're right, RSYS don't work in POST26. You must rotate the nodal coordinate system (NROTAT) to get the nodal results in different coordinates. You should do this before you solve, I suppose.

Regards,
Alex
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
nashki
  • Locked
  • Question Question
UDL on the Curve of Elbow
Replies
0
Views
3K
nashki
nashki
Sarikahirpara
  • Locked
  • Question Question
Modal analysis result interpretation
Replies
0
Views
280
Sarikahirpara
Sarikahirpara
md_salem
  • Locked
  • Question Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
914
Stick.
Stick.

Part and Inventory Search

Sponsor

Back
Top