Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

why is this sketch not fully defined 1

Status
Not open for further replies.
corey796

corey796

Industrial
Dec 6, 2011
7
US
Ok i cant move the circle but it shows as not being fully defend i cant add any relation's they over define the sketch so what do i do thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Even though the circle was drawn while being parallel to the Top Plane (or in the X-Z mode), the constraint isn't automatically added. I don't know if that is intended or a bug.
 
Upvote 0 Downvote
Not defined because it's in a 3d sketch. If it were based on a plane it would have been fully defined at that point (coincident center and radius).
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

JerryWong
  • Locked
  • Question
How to import attributes pre-defined in Solidworks? 4
Replies
8
Views
80
JerryWong
JerryWong
jassco
  • Question
Solidworks VBA to GET and SET dimensions on a sketch in an assembly model
Replies
1
Views
94
jassco
jassco
GhassanK
  • Locked
  • Question
SolidWorks Sketch Orientation 1
Replies
4
Views
52
jassco
jassco
Helepolis
  • Locked
  • Question
Display Pane Not Showing Sketch Colors
Replies
0
Views
15
Helepolis
Helepolis
arb65912cmco
  • Locked
  • Question
I can not select face in patterned components in upper level assembly
Replies
1
Views
74
arb65912cmco
arb65912cmco

Part and Inventory Search

Sponsor

Back
Top