Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

WILDFIRE: How to PivotDir Sweep????

Status
Not open for further replies.

DgenR8

Mechanical
Aug 28, 2001
14
ARRRGHHH!!!

Please help me learn how to do a Variable Section Sweep--> Pivot Dir sweep as in 2001. I see a drop down option for "Constant Normal Direction" in the Variable Section Sweep feature, but I can't seem to get the sketcher to open.

In 2001, all you needed was a trajectory and a normal reference plane that constrains your section...I'm not sure if that has changed.

Thanks for any help!
 
Replies continue below

Recommended for you

Hey all,

I figured it out...its simply renamed to the "Normal to Projection" option under the references flyout menu.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor