Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wire encoders and IMU's

Status
Not open for further replies.

pieterdevos

Automotive
Oct 26, 2013
2
Hello,

Anyone know where I can find Wire encoders that have an accuracy of 0.01 mm a length of approximately 200-300 mm ?

The only one I can find that comes close to this accuracy is A Celesco with an accuracy of 0.025 mm and a length of 500-600 mm.

Also anyone know where I can find good but cheap enough IMU = angle and acceleration sensors in one box (complete, not only chips). These would have to be small and easily mounted on a small cable (3 mm) and have to talk to a Siemens PLC through RS232 or 422 or Profinet,.. or wireless ones ?

Thank you for your help
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor