Hi all,
I'm trying to model very simple version of ball bearing.
Problem shows when I create "cycle wheel" instead of ball. Abaqus create hard point in every point where wires crossing each other. This causes that there is always a point in the centre of wheel. Which during analysis is blown into space.
Is there a possibility to create crossed wires without intersection points? I need single element through whole length of wire, not two trusses.
regards
Tomasz
I'm trying to model very simple version of ball bearing.
Problem shows when I create "cycle wheel" instead of ball. Abaqus create hard point in every point where wires crossing each other. This causes that there is always a point in the centre of wheel. Which during analysis is blown into space.
Is there a possibility to create crossed wires without intersection points? I need single element through whole length of wire, not two trusses.
regards
Tomasz
