Won't show the result ?

[fic]

Hy

I have created 3 variables in Mathcad and conected them with Pro/Engineer. 2 are from mc2proe and 1 is proe2mc.

It works ok, but when i open mathcad file it doesn't shov me the result enymore, it only shows litle black squares.(see attachment picture)
When I click on Format/Result and change it from 2 decimales to 2 it shows all results. But when I write new variable then it doesn't show it, an i do Format/Result change and then it shows it.

This happens only when I do MC-Proe integration.

I am bothering with this for days so if anyone could help my I would be very thankful.

 

[PetieSmo]

fic,

You might try hitting F9 or Ctrl+F9 (which is the 'Calculate' command in Mathcad)

Peter

 

[zdas04]

Take a look at thread552-253822 It sounds like your problem is similar to the problem I had.

David

 

[fic]

Peter,
yes Ctrl+F9 works but it's irritating pressing it every f***ing 5 min
I don't wont to touch anything in my calculations because than I will have to pres Ctrl+F9
and as the file grows it is getting slower and slower and slower to regeeeeeeeeeneraaaaaaaaate


David,
I saw that before but I don't think its that because it happened on three different computers I tried

 

[seymours2571]

Fic,

This is a known bug in MathCAD 14.0 that was first reported in datecode M011. It has been fixed in 14.0 M035.

Here is the PTC link:

https://www.ptc.com/appserver/cs/view/solution.jsp?n=142629

Steve



Stephen Seymour, PE
Seymour Engineering & Consulting Group

http://www.seymourecg.com

 

[fic]

hy

I solve the problem
Install ProE Wildfire 5.0 M010 and regenerate analysis

by and thanks