WRC Calculations on nozzle

[Mech2325]

Can anyone tell if PV ELITE considers pipe undertolerance while performing WRC calculations for nozzles?

When I run the analysis, it does take the pipe undertolerance while performing internal pressure calculations for nozzle, but for WRC, I saw in the report that the software has mentioned nominal thickness
I did not find any option to manually enter the nozzle thickness in WRC tab

 

[SnTMan]

Which WRC? No doubt you are aware that WRC 107 does not consider the attachment (nozzle) at all.

Really, Mech2325, I am going to suggest again that you study the software documentation, example problems and help files. This is a real strongpoint for PVE.

I'd also suggest you get a good pressure vessel handbook such as Moss. Answers to most of your questions will be found there.

You need do some of your own homework, and if possible find a mentor in your organization.

Regards,

Mike



The problem with sloppy work is that the supply FAR EXCEEDS the demand