Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Writing path data to file

Status
Not open for further replies.

izyk

Mechanical
Dec 4, 2006
21
Hi
How to write path data results to a text file using command line? I used PASAVE command but it writes in coded file so after that it's useless for me.
I would like to have a file like this one created in GUI: List -> results -> path data -> file -> save as.. but without following lines:

PRINT ALONG PATH DEFINED BY LPATH COMMAND. DSYS= 0

***** PATH VARIABLE SUMMARY *****

Thanks a lot
Regards
 
Replies continue below

Recommended for you

Hi,
For this purpose, I use the following "strategy" (other may exist):

/OUTPUT,filename,extension, ! redirects output to file
PRPATH,_UX,_UY ! prints path data
/OUTPUT ! resets output redirection

Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor