JaconHarbour
Mechanical
I cannot figure out what is going on here. In the default design library, the flanges in the routing -> piping -> flanges, are not correct on every size and class.
For example, the 2" 600# Weld Neck Flange, shows the raised face as being 3.31" in dia. , while every book, or website I can find shows it to be 3.62" in dia.
The B16.5 flanges I have downloaded from the Solidworks content are correct.
What standard is being followed for the default library?
For example, the 2" 600# Weld Neck Flange, shows the raised face as being 3.31" in dia. , while every book, or website I can find shows it to be 3.62" in dia.
The B16.5 flanges I have downloaded from the Solidworks content are correct.
What standard is being followed for the default library?
