Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

x-section patterning

Status
Not open for further replies.
KimBellingrath

KimBellingrath

Mechanical
May 14, 2003
103
0
0
US
Is there a way to pattern cross sections? I have patterned the datums that will control them and now have to create each x-section separately.
Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
No, unfortunately not (at least in 2001). But if you have your datums, then cross sections thru them are only few clicks away.

-Hora
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

freerangequark
  • Locked
  • Question
Patterning Issue - Timing Belt Model
Replies
7
Views
22
3DDave
3DDave
looslib
  • Locked
  • Question
Y14.3 Section lining
Replies
4
Views
5
looslib
looslib
Francis700
  • Locked
  • Question
Creo: Model Section Outline vs Drawing Text Colour - "Letter"
Replies
1
Views
8
DesEng1986
DesEng1986
jocaps
  • Locked
  • Question
hellical sweep section
Replies
1
Views
3
jocaps
jocaps
Korichnevijgigant
  • Locked
  • Question
Linked Section
Replies
4
Views
5
dgallup
dgallup
Back
Top