Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

x-section patterning

Status
Not open for further replies.
KimBellingrath

KimBellingrath

Mechanical
May 14, 2003
103
Is there a way to pattern cross sections? I have patterned the datums that will control them and now have to create each x-section separately.
Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
No, unfortunately not (at least in 2001). But if you have your datums, then cross sections thru them are only few clicks away.

-Hora
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

freerangequark
  • Locked
  • Question
Patterning Issue - Timing Belt Model
Replies
7
Views
1K
3DDave
3DDave
looslib
  • Locked
  • Question
Y14.3 Section lining
Replies
4
Views
257
looslib
looslib
Francis700
  • Locked
  • Question
Creo: Model Section Outline vs Drawing Text Colour - "Letter"
Replies
1
Views
320
DesEng1986
DesEng1986
jocaps
  • Locked
  • Question
hellical sweep section
Replies
1
Views
180
jocaps
jocaps
Korichnevijgigant
  • Locked
  • Question
Linked Section
Replies
4
Views
188
dgallup
dgallup

Part and Inventory Search

Sponsor

Back
Top Bottom