Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Yad/Yag Laser Cladding with 316 powder

Status
Not open for further replies.
alloyboy888

alloyboy888

Industrial
Jan 14, 2003
1
I am experiencing significant micro-cracking in 2nd and subsequent layers of 316 stainless steel powder applied to mild steel with my commercial Yad/Yag laser. I am feeding the powder into the beam externally. No pre-heat. Anyone got any thoughts?
 
Status
Not open for further replies.

Similar threads

Johnwoo1991
  • Locked
  • Question
Ball alve seats obtained from plate (A 240 316)
Replies
2
Views
240
SnTMan
SnTMan
SteveSnr
  • Locked
  • Question
Stainless 316 welding 1
Replies
1
Views
243
EdStainless
EdStainless
Laishetti
  • Locked
  • Question
Casting powder for 17-4 PH
Replies
5
Views
173
Laishetti
Laishetti
GabrieleB
  • Locked
  • Question
AISI 316 CLADD OVERLAY REPAIR 3
Replies
6
Views
332
EdStainless
EdStainless
rideHPD
  • Locked
  • Question
1/4, 1/2 Hard 316 Sheet, Availability/Experience?
Replies
8
Views
358
TugboatEng
TugboatEng

Part and Inventory Search

Sponsor

Back
Top Bottom