chas10
Structural
- Jan 2, 2008
- 10
Hi all
As part of a steel connection design, I have to check a rectangular steel plate supported on 3 sides. The plate is 180mm x 195mm with a bolt hole in the middle.
The plates supports a fixed/continuous.
I would like to use the yield Line theory to check the plate thickness to get a bit more economy.
Does anyone have a typical design example.
Many thanks
Charlie.
As part of a steel connection design, I have to check a rectangular steel plate supported on 3 sides. The plate is 180mm x 195mm with a bolt hole in the middle.
The plates supports a fixed/continuous.
I would like to use the yield Line theory to check the plate thickness to get a bit more economy.
Does anyone have a typical design example.
Many thanks
Charlie.